PAP2T or SPA2102 FAX OVER IP
To my Fellow (Filipino's) and the People Around the World, who need to configure their ATA. See below settings.
Step 1 Upgrade the ATA firmware to the latest version
Step 2 Ensure that you have enough bandwidth for uplink and downlink.
•For G.711 fallback, it is recommend to have ~100Kbps. (PAP2T)
•For T.38, allocate at least 50 kbps. (SPA2102)
Step 3 To optimize G.711 fallback fax completion rates, use the following settings on the
Line tab of the Linksys ATA:
•Network Jitter Buffer: very high
•Jitter buffer adjustment: disable
•Call Waiting: no
•3 Way Calling: no
•Echo Canceller: no
•Silence suppression: no
•Preferred Codec: G.711
•Use pref. codec only: yes
Step 4 If you are using a Cisco media gateway for PSTN termination, disable T.38 (fax relay) and enable fax using modem passthrough.
For example:
modem passthrough NSE payload-type 110 codec g711ulaw
fax rate disable
fax protocol pass-through g711ulaw
Step 5 Enable T.38 fax / Passthru_Method on the PAP 2T by configuring the following parameter on the Line tab for the FXS port to which the FAX machine is connected:
FAX_Passthru_Method: ReINVITE (for PAP2T while in SPA2102 = NSE)
Note If a T.38 call cannot be set-up, then the call should automatically revert to G.711 fallback.
Asterisk or any VOIP proxy server applicable but Need changes and updates in asterisk for you able to use FOIP.
I hope this information will help you to configure the ATA device.
ehrwin
Step 1 Upgrade the ATA firmware to the latest version
Step 2 Ensure that you have enough bandwidth for uplink and downlink.
•For G.711 fallback, it is recommend to have ~100Kbps. (PAP2T)
•For T.38, allocate at least 50 kbps. (SPA2102)
Step 3 To optimize G.711 fallback fax completion rates, use the following settings on the
Line tab of the Linksys ATA:
•Network Jitter Buffer: very high
•Jitter buffer adjustment: disable
•Call Waiting: no
•3 Way Calling: no
•Echo Canceller: no
•Silence suppression: no
•Preferred Codec: G.711
•Use pref. codec only: yes
Step 4 If you are using a Cisco media gateway for PSTN termination, disable T.38 (fax relay) and enable fax using modem passthrough.
For example:
modem passthrough NSE payload-type 110 codec g711ulaw
fax rate disable
fax protocol pass-through g711ulaw
Step 5 Enable T.38 fax / Passthru_Method on the PAP 2T by configuring the following parameter on the Line tab for the FXS port to which the FAX machine is connected:
FAX_Passthru_Method: ReINVITE (for PAP2T while in SPA2102 = NSE)
Note If a T.38 call cannot be set-up, then the call should automatically revert to G.711 fallback.
Asterisk or any VOIP proxy server applicable but Need changes and updates in asterisk for you able to use FOIP.
I hope this information will help you to configure the ATA device.
ehrwin
0 Comments:
Post a Comment
<< Home